This website uses cookies to give you the best experience. By using this website you consent to the use of the cookies. Cookie Policy
Categories
- ADAPTERS (521)
- INNESTI RAPIDI (77)
- CRIMP FITTINGS (880)
- DIN FITTINGS (201)
- FLEX TUBE (100)
- VALVES AND REGULATORS (105)
- HOSE BURST VALVE (4)
- DOUBLE OVERCENTRE VALVE (11)
- BY PASS VALVE (8)
- DOUBLE PILOT OPERATED CHECK VALVE (14)
- SINGLE PILOT OPERATED CHECK VALVE (4)
- SHUTTLE VALVE (2)
- END STROKE VALVE (4)
- THROTTLE VALVE (19)
- CHECK VALVE (6)
- PLOUGH OVERTURNING VALVE (2)
- 2 WAYS FLOW DIVIDER VALVE (8)
- DUAL CROSS RELIEF VALVE (3)
- TWO PUMP ''HI-LOW'' UNLOADING VALVE (3)
- RELIEF VALVE (6)
- SEQUENCE VALVE (2)
- VALVOLA DI CONTROLLO DIREZIONALE (1)
- CARTRIDGE VALVE (5)
- VALVOLA MODULARE REGOLATORE DI FLUSSO CETOP 3 (2)
- VALVOLA DI BLOCCO E CONTROLLO DISCESA A SEMPLICE EFFETTO A FLANGIA (1)
- ELETTROVALVOLE E DISTRIBUTORI (71)
- Clamp (22)
- MANOMETRO ALLA GLICERINA (8)
- TRATTENITORE DI SICUREZZA PER TUBO FLESSIBILE (15)
- RUBINETTO SFERA (7)
- ROTATING COUPLING (23)
- MOTORI IDRAULICI (8)
- TUBO ACCIAIO RICOTTO (37)
- POMPE (78)
- IDROGUIDA (6)
Last watched
Azienda associata
Accedi al configuratore
VALVOLA DI BLOCCO S.E.CONTROLLO DISCESA 1/2'' ACCIAIO TIPO A
| Price: |
|
|---|---|
| Item code: | V2190A800 |
| Weight: | 1,200 Kg |
| Quantity: |
Users feedback
Description
Overcenter valve acting in lineUse
This valve is used to control movement and lock the actuator in one direction and made the following functions:
* controlled descent of the load does not carry it by its own weight, as the valve prevents any cavitations of the actuator
* limited maximum pressure in case of shocks created by loads, overloads or sudden manoeuvrings (load control with closed-center circuit). It is insensitive to back pressure and is therefore used where normal overcentre not work properly to load control
Materials and characteristics
Body: steel
Internal parts: hardened and ground
Seals: BUNA N standard
Tightness: minor leakage
Mounting
Connect V1 and V2 to, C1 to the free flow side of the actuator and C2 to the actuator side where you want the seal. Assembly is in line. The setting of the valve must be at least 1.3 times higher than the load pressure to allow the valve to close even when subjected to the pressure corresponding to the maximum load.
